D-Link xStack DES-6500 Cli Manual page 206

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
Each command is listed, in detail, in the following sections.
enable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable 802.1x switch wide:
D E S - 6 5 0 0 : 4 # e n a b l e 8 0 2 . 1 x
C o m m a n d : e n a b l e 8 0 2 . 1 x
S u c c e s s .
D E S - 6 5 0 0 : 4 #
disable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable 802.1x on the Switch:
D E S - 6 5 0 0 : 4 # d i s a b l e 8 0 2 . 1 x
C o m m a n d : d i s a b l e 8 0 2 . 1 x
S u c c e s s .
D E S - 6 5 0 0 : 4 #
Used to enable the 802.1x server on the Switch.
enable 802.1x
The enable 802.1x command enables the 802.1x Network Access
control server application on the Switch. To select between port-based
or MAC-based, use the config 802.1x auth_mode command.
None.
Only Administrator-level users can issue this command.
Used to disable the 802.1x server on the Switch.
disable 802.1x
The disable 802.1x command is used to disable the 802.1x Network
Access control server application on the Switch. To select between
port-based or MAC-based, use the config 802.1x auth_mode
command.
None.
Only Administrator-level users can issue this command.
202