D-Link xStack DES-6500 Cli Manual page 142

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
D E S - 6 5 0 0 : 4 # c r e a t e l i n k _ a g g r e g a t i o n g r o u p _ i d 1
C o m m a n d : c r e a t e l i n k _ a g g r e g a t i o n g r o u p _ i d 1
S u c c e s s .
D E S - 6 5 0 0 : 4 #
delete link_aggregation group_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete link aggregation group:
D E S - 6 5 0 0 : 4 # d e l e t e l i n k _ a g g r e g a t i o n g r o u p _ i d 6
C o m m a n d : d e l e t e l i n k _ a g g r e g a t i o n g r o u p _ i d 6
S u c c e s s .
D E S - 6 5 0 0 : 4 #
config link_aggregation
Purpose
Syntax
Description
Used to delete a previously configured link aggregation group.
delete link_aggregation group_id <value 1-32>
This command is used to delete a previously configured link
aggregation group.
<value 1-32>  Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number
identifies each of the groups.
Only Administrator-level users can issue this command.
Used to configure a previously created link aggregation group.
group_id <value 1-32> {master_port <port> | ports <portlist> state
[enabled | disabled]}
This command allows the configuration of a link aggregation group that
was created with the create link_aggregation command above.
138