D-Link xStack DES-6500 Cli Manual page 85

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
D E S - 6 5 0 0 : 4 # d e l e t e s y s l o g h o s t 4
C o m m a n d : d e l e t e s y s l o g h o s t 4
S u c c e s s .
D E S - 6 5 0 0 : 4 #
show syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show syslog host information:
D E S - 6 5 0 0 : 4 # s h o w s y s l o g h o s t
C o m m a n d : s h o w s y s l o g h o s t
S y s l o g G l o b a l S t a t e : D i s a b l e d
H o s t I d H o s t I P A d d r e s s
- - - - - - - - - - - - - - - - - - - - - -
1 1 0 . 1 . 1 . 2
2 1 0 . 4 0 . 2 . 3
3 1 0 . 2 1 . 1 3 . 1
T o t a l E n t r i e s : 3
D E S - 6 5 0 0 : 4 #
config system_severity
Purpose
Syntax
Description
Used to display the syslog hosts currently configured on the
Switch.
show syslog host {<index 1-4>}
The show syslog host command is used to display the syslog
hosts that are currently configured on the Switch.
<index 1-4>  Specifies that the command will be applied to an
index of hosts. There are four available indexes, numbered 1
through 4.
None.
S e v e r i t y
- - - - - - - - - - - - - -
A l l
A l l
A l l
To configure when and where severity messages are to be
recorded.
config system_severity [trap | log | all] [critical | warning |
information]
This command is used to configure the system severity levels on the
Switch. When an event occurs on the Switch, a message will be sent
81
F a c i l i t y U D P p o r t
- - - - - - - - - - - - - - - -
L o c a l 0 5 1 4
L o c a l 0 5 1 4
L o c a l 0 5 1 4
S t a t u s
- - - - - -
D i s a b l e d
D i s a b l e d
D i s a b l e d