D-Link xStack DES-6500 Cli Manual page 341

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
DES-6500:4#show ospf
Command: show ospf
OSPF Interface Settings
Interface
------------ ------------------ --------------- -------- --------- ---------
System
Total Entries : 1
OSPF Area Settings
Area ID
--------------- ------ ----------------------- -----------------
0.0.0.0
Total Entries : 1
DES-6500:4#
create ospf area
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To create an OSPF area:
DES-6500:4#create ospf area 10.48.74.122 type normal
Command: create ospf area 10.48.74.122 type normal
Success.
IP Address
10.90.90.90/8
Type Stub Import Summary LSA Stub Default Cost
Normal None
Used to configure OSPF area settings.
create ospf area <area_id> type [normal | stub {stub_summary
[enabled | disabled] | metric <value 0-65535>}]
This command is used to create an OSPF area and configure its
settings.
<area_id>  The OSPF area ID. The user may enter a 32-bit number
in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
type [normal | stub]  The OSPF area mode of operation  stub or
normal.
stub_summary [enabled | disabled]  Enables or disables the OSPF
area to import summary LSA advertisements.
metric <value 0-65535>  The OSPF area cost between 0 and 65535.
0 denotes that the value will be automatically assigned. The default
setting is 0.
Only Administrator-level users can issue this command.
Area ID State
0.0.0.0 Disabled Link Up
None
337
Link Metric
Status
1