D-Link xStack DES-6500 Cli Manual page 161

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
To set up static router ports:
D E S - 6 5 0 0 : 4 # c o n f i g r o u t e r _ p o r t s d e f a u l t a d d 2 : 1 - 2 : 1 0
C o m m a n d : c o n f i g r o u t e r _ p o r t s d e f a u l t a d d 2 : 1 - 2 : 1 0
S u c c e s s .
D E S - 6 5 0 0 : 4 #
config router_ports_forbidden
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set up forbidden router ports:
D E S - 6 5 0 0 : 4 # c o n f i g r o u t e r _ p o r t s _ f o r b i d d e n d e f a u l t a d d
2 : 1 - 2 : 1 0
C o m m a n d : c o n f i g r o u t e r _ p o r t s _ f o r b i d d e n d e f a u l t a d d
2 : 1 - 2 : 1 0
S u c c e s s .
D E S - 6 5 0 0 : 4 #
Used to configure ports as forbidden multicast router ports.
config router_ports_forbidden <vlan_name 32> [add | delete]
<portlist>
This command allows you to designate a port or range of ports as
being forbidden to multicast-enabled routers. This will ensure that
multicast packets will not be forwarded to this port  regardless of
protocol, etc.
<vlan_name 32>  The name of the VLAN on which the router port
resides.
[add | delete] - Specifies whether to add or delete forbidden ports to
the specified VLAN.
<portlist>  Specifies a range of ports that will be configured as
forbidden router ports. The port list is specified by listing the lowest
line card number and the beginning port number on that line card,
separated by a colon. Then the highest line card number, and the
highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated
by a dash. For example, 1:3 specifies line card number 1, port 3. 2:4
specifies line card number 2, port 4. 1:3-2:4 specifies all of the ports
between line card 1, port 3 and line card 2, port 4  in numerical
order.
Only Administrator-level users can issue this command.
157