Complete Hardware Guide for EX3300 Ethernet Switches
Related
Documentation
Mounting an EX3300 Switch on a Wall
92
Figure 28: Attaching Rubber Feet to a Switch Chassis
Connecting AC Power to an EX3300 Switch on page 105
Connecting DC Power to an EX3300 Switch on page 107
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 119
Clearance Requirements for Airflow and Hardware Maintenance for EX3300 Switches
on page 66
You can mount an EX3300 switch on a wall by using the separately orderable wall-mount
kit.
WARNING:
When mounting an EX3300 switch chassis in a vertical position, orient the
front panel of the chassis downward to ensure proper airflow and meet
safety requirements in the event of a fire.
Install the wall-mount baffle above the units to reduce the risk of objects
or substances falling into the air exhaust or power supply, which could
cause a fire.
Before mounting the switch on a wall:
Verify that the site meets the requirements described in
for EX3300 Switches" on page
Read
"General Safety Guidelines and Warnings" on page
to
"Chassis Lifting Guidelines for EX3300 Switches" on page
Ensure that you have the following parts and tools available:
2 wall-mount brackets (provided in the wall-mount kit)
12 wall-mount bracket screws (provided in the wall-mount kit)
6 mounting screws (8-32 x 1.25 in. or M4 x 30 mm) (not provided)
Rubber feet
"Site Preparation Checklist
55.
149, with particular attention
Copyright © 2015, Juniper Networks, Inc.
163.