Connecting Qfx Series And Ex Series Switches In A Qfx Virtual Chassis - Juniper EX4300 Series Hardware Manual

3. Insert the cable connector into the optical transceiver (see
Figure 76: Connect a Fiber-Optic Cable to an Optical Transceiver Installed in a Device
4. Secure the cables so that they do not support their own weight. Place excess cable out of the way in
a neatly coiled loop. Placing fasteners on a loop helps cables maintain their shape.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend radius. An arc
smaller than a few inches in diameter can damage the cables and cause problems that
are difficult to diagnose.
Do not let fiber-optic cables hang free from the connector. Do not allow fastened
loops of cables to dangle, which stresses the cables at the fastening point.
Connecting QFX Series and EX Series Switches in a
QFX Virtual Chassis
IN THIS SECTION

Connecting QFX Series and EX Series Switches in a QFX Virtual Chassis | 214

Figure 76 on page
Fiber-optic Transceiver
cable
213).
213