Connecting And Configuring An Ex Series Switch (Cli Procedure) - Juniper EX3200 Series Complete Hardware Manual

Related Topics

Connecting and Configuring an EX Series Switch (CLI Procedure)

Copyright © 2010, Juniper Networks, Inc.
lldp-med {
interface all;
}
rstp;
}
ethernet-switching-options {
storm-control {
interface all;
}
}
poe {
interface all;
}
Reverting to the Default Factory Configuration for the EX Series Switch
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 165
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 167
Understanding Configuration Files for EX Series Switches
EX Series Switches Interfaces Overview
There are two ways to connect and configure an EX Series switch: one method is through
the console using the CLI and the other is using the J-Web interface. This topic describes
the CLI procedure.
NOTE: To run the
ezsetup
as the active configuration. If you have configured anything on the switch and want to
run ezsetup , revert to the factory default configuration. See Reverting to the Default
Factory Configuration for the EX Series Switch.
Before you begin connecting and configuring an EX Series switch through the console
using the CLI:
Set the following parameter values in the console server or PC:
Baud Rate—9600
Flow Control—None
Data—8
Parity—None
script, the switch must have the factory default configuration
Chapter 12: Performing Initial Configuration
165