Removing The Defective Intrusion Switch Cable - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

Cabling

16.3.2 Removing the defective intrusion switch cable

Figure 319: Disconnecting the intrusion switch cable
Ê Disconnect the intrusion switch cable from the system board (see circle).
Ê Remove the intrusion switch cable from the cable guide (A) and the cable
clamps (see arrows) on the HDD cage.
Figure 320: Removing the intrusion switch holder (A)
Ê Remove one screw from the intrusion switch holder as shown.
410 Upgrade and Maintenance Manual
TX150 S8 / TX200 S7