Replacing The Intrusion Switch Cable; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

16.3

Replacing the intrusion switch cable

Field Replaceable Units (FRU)
Average task duration: 10 minutes

16.3.1 Required tools

Preliminary and concluding steps: tool-less
●
Removing the intrusion switch cable:
●
– Phillips PH2 / (+) No. 2 screw driver

16.3.2 Preliminary steps

Before removing the intrusion, perform the following steps:
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page 69.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 77 (rack server) or
server).
Ê Remove the air duct as described in section
on page 98.
Ê Remove the system fan holder as described in section
system fan holder" on page
TX300 S7 / RX350 S7
62.
70.
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
386.
Upgrade and Maintenance Manual
"Locating the defective
"Shutting down the server" on
"Disconnecting the server
75.
"Removing the top cover"
"Removing the system air duct"
"Removing the
Cabling
74.
(tower
881