Remote Connections (Network Interface) - Edge-Core ECS4120-28F Reference Manual

28/52-port layer 2+ gigabit ethernet switch
Hide thumbs Also See for ECS4120-28F:
Table of Contents

Advertisement

Chapter 1
| Initial Switch Configuration
Connecting to the Switch
Remote Connections
(Network Interface)
Username: admin
Password:
CLI session with the ECS4120-28T* is opened.
To end the CLI session, enter [Exit].
Console#configure
Console(config)#username guest password 0 [password]
Console(config)#username admin password 0 [password]
Console(config)#
* This manual covers the ECS4120-28T/52T Gigabit Ethernet switches, the
ECS4120-28F/28F-I Gigabit Ethernet fiber switch, and the ECS4120-28P Gigabit
Ethernet PoE switch. Other than the difference in port types, and support for
PoE (ECS4120-28P), there are no significant differences. Therefore most of the
screen display examples are based on the ECS4120-28T.
Prior to accessing the switch's onboard agent via a network connection, you must
first configure the switch's network interface with a valid IPv4 or IPv6 address.
The default network interface is VLAN 1 which includes ports 1-28/52. When
configuring the network interface, the IP address, subnet mask, and default
gateway may all be set using a console connection, or DHCP protocol as described
in the following sections.
An IPv4 address for the primary network interface is obtained via DHCP by default.
To manually configure this address or enable dynamic address assignment via
DHCP, see
"Setting an IP Address" on page
After configuring the switch's IP parameters, you can access the onboard
configuration program from anywhere within the attached network. The onboard
configuration program can be accessed using Telnet or SSH from any computer
attached to the network. The switch can also be managed by any computer using a
web browser (Internet Explorer 11, Mozilla Firefox 52, or Google Chrome 57, or
more recent versions).
Note:
This switch supports eight Telnet sessions or SSH sessions.
The onboard program only provides access to basic configuration functions. To
access the full range of SNMP management functions, you must use SNMP-based
network management software.
51.
– 50 –

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecs4120-28f-iEcs4120-28tEcs4120-28pEcs4120-52t

Table of Contents