Interface Configuration; Port Configuration; Configuring By Port List - Edge-Core ES3510MA-DC Management Manual

5
P C
ORT ONFIGURATION
C
ONFIGURING BY
P L
ORT IST
I
NTERFACE
This chapter describes the following topics:

Port Configuration

– Configures connection settings, including auto-
◆
negotiation, or manual setting of speed, duplex mode, and flow control.
Local Port Mirroring
◆
the local switch.
Remote Port Mirroring
◆
switches for analysis at a destination port on the local switch.
Displaying Statistics
◆
statistics in table or chart form.
◆ Cable Test – Performs cable diagnostics on the specified port.
Trunk Configuration
◆
Saving Power – Adjusts the power provided to ports based on the
◆
length of the cable used to connect to other devices.
Traffic Segmentation
◆
segmented group of ports.
VLAN Trunking – Configures a tunnel across one or more intermediate
◆
switches which pass traffic for VLAN groups to which they do not
belong.
This section describes how to configure port connections, mirror traffic
from one port to another, and run cable diagnostics.
Use the Interface > Port > General (Configure by Port List) page to enable/
disable an interface, set auto-negotiation and the interface capabilities to
advertise, or manually fix the speed, duplex mode, and flow control.
CLI R
EFERENCES
"Interface Commands" on page 719
◆
– 127 –
C
ONFIGURATION
– Sets the source and target ports for mirroring on
– Configures mirroring of traffic from remote
– Shows Interface, Etherlike, and RMON port
– Configures static or dynamic trunks.
– Configures the uplinks and down links to a