Interface Configuration - Edge-Core AS6700-32X Cli Reference Manual

Chapter 10
| Interface Commands

Interface Configuration

Interface Configuration
interface
Table 69: Interface Commands
Command
transceiver-threshold
rx-power
transceiver-threshold
temperature
transceiver-threshold
tx-power
transceiver-threshold
voltage
show interfaces transceiver
show interfaces transceiver-
threshold
Cable Diagnostics
test loop internal
show loop internal
This command configures an interface type and enters interface configuration
mode. Use the no form with a trunk to remove an inactive interface.
Syntax
[no] interface interface-list
interface-list – One or more ports. Use a hyphen to indicate a consecutive
list of ports or a comma between non-consecutive ports.
craft - Management port on the front panel.
ethernet unit/port-list
unit - Unit identifier. (Range: 1)
port-list - Physical port number or list of port numbers. Separate
nonconsecutive port numbers with a comma and no spaces; or use
a hyphen to designate a range of port numbers. (Range: 1-32/54)
port-channel channel-id (Range: 1-27)
vlan vlan-id (Range: 1-4094)
Default Setting
None
Command Mode
Global Configuration
(Continued)
Function
Sets thresholds for the transceiver power level of the
received signal which can be used to trigger an alarm or
warning message
Sets thresholds for the transceiver temperature which can
be used to trigger an alarm or warning message
Sets thresholds for the transceiver power level of the
transmitted signal which can be used to trigger an alarm or
warning message
Sets thresholds for the transceiver voltage which can be
used to trigger an alarm or warning message
Displays the temperature, voltage, bias current, transmit
power, and receive power
Displays the alarm/warning thresholds for temperature,
voltage, bias current, transmit power, and receive power
Performs an internal loop back test on the specified port
Shows the results of a loop back test
– 360 –
Mode
IC
IC
IC
IC
PE
PE
PE
PE