Setting The Routing - Fujitsu M10 Installation Manual

bb#00-if#2 address [169.254.1.17 ] > [Enter] key
bb#01-if#2 address [169.254.1.18 ] > [Enter] key
7.5.5

Setting the routing

1.
Execute the showroute command to display the routing environment.
XSCF> showroute -a
Destination Gateway Netmask Flags Interface
Destination Gateway Netmask Interface
2.
Execute the setroute command to set the default gateway.
For -n address, specify the IP address that is the routing information destination.
If 0.0.0.0 is specified in address, the command sets the default routing information.
For -g address, specify the gateway address used in routing.
For interface, specify the network interface to be set. You can specify it as follows
depending on the system configuration:
- SPARC M10-1/M10-4/M10-4S (no crossbar box): bb#00-lan#0, bb#00-lan#1,
- M10-4S (with crossbar boxes): xbbox#80-lan#0, xbbox#80-lan#1, xbbox#81-
XSCF> setroute -c add -n address -g address interface
The following example adds the default gateway IP address 192.168.1.1 for
XSCF-LAN#0 of BB#00.
XSCF> setroute -c add -n 0.0.0.0 -g 192.168.1.1 bb#00-lan#0
The following example adds the default gateway IP address 192.169.1.1 for
XSCF-LAN#1 of XBBOX#80.
XSCF> setroute -c add -n 0.0.0.0 -g 192.168.2.1 xbbox#80-lan#1
7.5.6 Applying network settings
To complete configuration of the network, settings must be reflected and the XSCF
must be reset. The XSCF reset disconnects the XSCF session, so log in again.
1.
Execute the applynetwork command on the XSCF shell.
Execution of the command displays the network settings, so you can confirm the
bb#01-lan#0, bb#01-lan#1
lan#0, xbbox#81-lan#1
Chapter 7 Making the Initial System Settings 211