Removing The Server While The Target Physical Partition (Ppar Is Operating - Fujitsu M10 Installation Manual

M10-4S units in the system.
Therefore, if there is a physical partition with the same number as that of the BB-ID
of the SPARC M10-4S to be removed, stop that physical partition before removing
the unit.
This physical partition becomes unavailable after removal. So reconfigure the
physical partition with a different physical partition number.
10.2.1 Removing the server while the target physical
partition (PPAR) is operating
This section describes the removal procedure on the system in
Configuration example of
while the target physical partition (PPAR) is in operation. To perform maintenance
while the physical partition (PPAR) is operating, use dynamic reconfiguration (DR)
for the physical partition.
For the software requirements required for this operation, see the latest Fujitsu
M10/SPARC M10 Systems Product Notes and Oracle VM Server for SPARC 3.2
Administration Guide.
For details on the XSCF commands executed in each step, see the Fujitsu M10/SPARC
M10 Systems XSCF Reference Manual.
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
278
2BB" from a 2BB configuration to a 1BB configuration
"Figure 10-1