Fujitsu M10 Installation Manual page 219

M10-1/M10-4/1BB configuration of the M10-4S
In the systems with one XSCF, set either or both of the following IP addresses:
- XSCF-LAN#0 of BB#00
- XSCF-LAN#1 of BB#00
Figure 7-1 Example of XSCF-LAN settings
BB#00
Master XSCF
LAN#0 LAN#1
192.168.1.x (1) 192.168.2.a (1)
Remarks - Configure the XSCF-LAN#0 and XSCF-LAN#1 ports such that they are on
different subnets. (See (1) in
1.
Execute the setnetwork command with network interface information specified.
The following example sets the IP addresses and net masks for XSCF-LAN#0 and
XSCF-LAN#1 of BB#00 to enable them.
XSCF> setnetwork bb#00-lan#0 -m 255.255.255.0 192.168.1.x
XSCF> setnetwork bb#00-lan#1 -m 255.255.255.0 192.168.2.a
SPARC M10-4S (no crossbar box)
In the systems with multiple XSCFs, first set each XSCF-LAN IP address on the
master XSCF side, and then set the XSCF-LAN IP address on the standby XSCF.
- XSCF-LAN#0 of BB#00 (master XSCF)
- XSCF-LAN#1 of BB#00 (master XSCF)
- XSCF-LAN#0 of BB#01 (standby XSCF)
- XSCF-LAN#1 of BB#01 (standby XSCF)
Figure 7-1.)
Chapter 7 Making the Initial System Settings 205