Fujitsu M10 Installation Manual page 308

4.
Execute the deleteboard command from the master XSCF to release a system
board (PSB) from the physical partition configuration.
The following example releases system boards 04-0, 05-0, 06-0, 07-0, 08-0, 09-0,
10-0, and 11-0 from the physical partition.
XSCF> deleteboard -c unassign 04-0 05-0 06-0 07-0 08-0 09-0 10-0 11-0
PSB#04-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
PSB#05-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
PSB#06-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
PSB#07-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
PSB#08-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
PSB#09-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
PSB#10-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
PSB#11-0 will be unassigned from PPAR immediately. Continue?[y|n] : y
5.
Execute the showresult command, and confirm the end status of the
previously executed deleteboard command.
In the following example, 0 is returned as the end status, so the execution of the
deleteboard command has completed correctly.
XSCF> showresult
0
6.
Execute the showboards command to check the system board (PSB) status.
In the following example, system boards 04-0, 05-0, 06-0, 07-0, 08-0, 09-0, 10-0,
and 11-0 are in the system board pool.
XSCF> showboards -a
PSB PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00) Assigned n n n Passed Normal
01-0 00(01) Assigned n n n Passed Normal
02-0 00(02) Assigned n n n Passed Normal
03-0 00(03) Assigned n n n Passed Normal
04-0 SP Available n n n Passed Normal
05-0 SP Available n n n Passed Normal
06-0 SP Available n n n Passed Normal
07-0 SP Available n n n Passed Normal
08-0 SP Available n n n Passed Normal
09-0 SP Available n n n Passed Normal
10-0 SP Available n n n Passed Normal
11-0 SP Available n n n Passed Normal
7.
Execute the initbb command from the master XSCF to release the SPARC
M10-4S to be removed from the system and initialize it.
In bb_id, specify the ID (BB-ID) identifying the chassis.
XSCF> initbb -b bb_id
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
294