Fujitsu M10 Installation Manual page 111

column of the rack, and align the protrusions on the slide rail with the holes
in the supporting column (attachment locations). Then, push back the slide
rail. (The latch clicks at this time.)
c. Pull the slide rail until the front of the rail meets the front of the front
supporting column of the rack. Align the protrusions on the slide rail with the
holes in the supporting column (attachment locations). Then, push the slide
rail to the rear of the rack until it clicks and locks. Confirm that the attached
slide rail is firmly locked by shaking it gently.
d. Attach the slide rail on the other side in the same manner.
Figure 3-26 Attaching the slide rail
FRONT
Remarks - To remove the slide rail, release the lock by pressing the part indicated by A in
Figure 3-27, and pull the slide rail forward.
REAR
Chapter 3 Installing the System 97