Fujitsu M10 Installation Manual page 139

Figure 3-68 Removing pins from the Type-1 rail
- For the Type-2 rail
Remove the pins at the front and rear of the rail.
a. Remove the pins (A in
rails.
b. Store the removed pins (four pins in total) for future use when the chassis is
moved.
Figure 3-69 Removing pins from the Type-2 rail
4.
Remove each screw from the side of the rail.
For the Type-1 rail, remove the one screw (A in
rail.
For the Type-2 rail, loosen the two screws (B in
rail.
A B
Figure 3-69) at the front and rear of the left and right
A
Figure 3-70) from the side of the
Figure 3-71) from the side of the
Chapter 3 Installing the System 125