Fujitsu M10 Installation Manual page 256

Note - If no SSCP IP address is set, an error occurs.
Note - The addfru command cannot specify multiple chassis. Install one chassis at a time.
Note - When the addfru command is executed, the firmware of the building block to be
installed is automatically matched to the version of the firmware of the building block in
which the master XSCF is operating. It is recommended that you update the XCP of the
master XSCF to the latest version beforehand.
XSCF> addfru
-----------------------------------------------------------------------
Maintenance/Addition Menu
Please select the chassis including added FRU.
No. FRU Status
--- ------------------- --------------
1 /BB#0 Normal
2 /BB#1 Unmount
3 /BB#2 Unmount
4 /BB#3 Unmount
-----------------------------------------------------------------------
Select [1-16|c:cancel] : 2
Maintenance/Addition Menu
Please select the BB or a type of FRU to be added.
1. BB itself
2. PSU (Power Supply Unit)
-----------------------------------------------------------------------
Select [1,2|c:cancel] : 1
Maintenance/Addition Menu
Please select a FRU to be added.
No. FRU Status
--- ------------------- --------------
1 /BB#1 Unmount
-----------------------------------------------------------------------
Select [1|b:back] : 1
You are about to add BB#1.
Do you want to continue?[a:add|c:cancel] : a
Please execute the following steps:
1) After the added device is connected with the system,
please turn on the breaker of the BB#1.
2) Please select[f:finish] :
b. Mount the target SPARC M10-4S in the rack.
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
242
The following example installs BB#1.
Mount the target SPARC M10-4S in the rack when the above message, "1)
After the added device is connected with the system, please turn on the