Connecting Cables To The Pci Expansion Unit - Fujitsu M10 Installation Manual

5.
Connect the supplied power cords to the power supply units (A in
Secure the power cords with a power clamp.
Figure 5-6 Power supply unit locations
A
Note - Do not connect to an outlet at this point.
5.3 Connecting Cables to the PCI
Expansion Unit
This section describes the procedure for connecting the management cable, link
cables, and power cords to the PCI expansion unit.
1.
Connect the management cable.
Connect the link board of the PCI expansion unit and the link card of the chassis
by using the management cable. (See A in
Figure
2.
Connect link cables.
Connect the cables such that the port indications on the link card and link board
match the labels on the cables.
Each port on the link card and link board is color-coded and numbered. Connect
the port to the corresponding port of the same color and number.
Note - The two link cables are the same. The labels on both ends of each cable have the same
indications. When laying the cables, check their connections to confirm that the ends of the
cables connected to the link card and link board are at the same locations as shown on the
5-10.)
Figure 5-8, A in Figure
Chapter 5 Connecting Cables to the Chassis
Figure 5-6).
5-9, and A in
167