Rack With A Width Of 600 Mm (23.6 In.) - Fujitsu M10 Installation Manual

Figure 5-15 Example of stored cables (4BB configuration)
5.5.2

Rack with a width of 600 mm (23.6 in.)

For a rack with a width of 600 mm (23.6 in.), there is not enough space at a side of the
rack. You need to distribute cables appropriately to the left and right sides and
bundle them together there. This section describes the recommended method of
storing the cables by using the 3BB configuration and 4BB configuration as examples.
Store the cables properly according to the rack used.
4BB configuration
For the 4BB configuration, place the crossbar cables connected to the 2L and 2R ports
of XBU#0/#1 together at the right side as viewed from the rear of the rack. Place the
other crossbar cables together at the left side as viewed from the rear of the rack.
1.
Hang the power cords from the left side as viewed from the rear of the rack.
Place the power cords over the cable support fixing bracket to hang them there
as is.
2.
Place the crossbar cables connected to the 0L/0R and 1L/1R ports of each
XBU together at the left side as viewed from the rear of the rack.
3.
Secure the crossbar cables placed together at the left side to the cable
support with hook-and-loop fastener strips.
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
174