Installation Area For A General Rack - Fujitsu M10 Installation Manual

rack.
2.4.2

Installation area for a general rack

Service areas
Service area requirements vary depending on the rack used.
When using an expansion rack, see
When mounting each chassis in the designated rack, see the examples of service areas
in Figure
When using a rack other than the designated rack, see the manual for the rack used.
Figure 2-5 Example of service areas for the SPARC M10-1 (top view)
600 mm
(23.6 in.)
*1 This area is required on either the left or right side.
*2 To mount a chassis on the rack, an area with a depth of 1,200 mm (47.2 in.) is required in front of the rack.
If there is a possibility that a chassis will be added later, secure an area with a depth of 1,200 mm (47.2 in.) in front
of the rack.
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
28
2-5, Figure 2-7, and
Rear service area
Rack
Front service area
(*1)
(*2)
700 mm
(27.6 in.)
"2.4.4 Installation area for an expansion
Figure 2-8. The rack width depends on the rack used.
(*1) (*1)
600 mm
(23.6 in.)
rack."
800 mm
(31.5 in.)
105 0 mm
(41.3 in.)
900 mm
(35.4 in.)