Registering A Cpu Activation Key - Fujitsu M10 Installation Manual

7.11

Registering a CPU Activation Key

7.11.1 CPU Activation key application conditions
The unit of a CPU Activation key is two cores, and you can enter any CPU
■
Activation key individually into a purchased, borrowed, or leased SPARC M10
system. The key makes available two CPU cores, which are assigned in units of a
single core to a physical partition.
A single CPU Activation key cannot be entered and used with multiple SPARC
■
M10 systems at the same time.
Once entered on a SPARC M10 system, a CPU Activation key can be deleted from
■
that system and re-entered on another SPARC M10 system. Also, a CPU
Activation key purchased for a SPARC64 X processor can be deleted from a
SPARC M10 system, and then re-entered on a system in which a SPARC64 X+
processor is mounted. However, both SPARC M10 systems where the key is
entered must be the same model. Furthermore, the SPARC M10 systems cannot
belong to different customers.
The number/type of software licenses used with the licensed CPU cores differs
■
depending on the software. It is the responsibility of the customer to confirm that
proper software licenses are installed for the addition of licensed CPU cores.
7.11.2 Checking a CPU Activation key
1.
Execute the showcodactivation command to check the CPU Activation key
information.
In the following example, no CPU Activation key has been installed.
In this case, perform the work in
XSCF> showcodactivation
Index Description Count
------- ----------- ------
In the following example, a CPU Activation key has already been installed. In
this case, skip
Assigning CPU Core
XSCF> showcodactivation
Index Description Count
------- ----------- ------
0 PROC 2
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
220
"7.11.3 Registering a CPU Activation
"7.11.3 Registering a CPU Activation
Resources."
key."
key" and go to "7.12