Performing The Work Of Installing The Expansion Racks - Fujitsu M10 Installation Manual

For the procedure for mounting in the rack, see
M10-4/SPARC M10-4S in a
9.5.2 Performing the work of installing the expansion
racks
This section describes the procedure for connecting power cords to the power
distribution units (PDUs) of expansion racks 1 and 2, and then connecting and
installing the racks.
1.
Confirm the delivered components of expansion rack 1 and expansion rack 2.
For details, see
rack."
2.
Before installing the rack, connect the power cords to a power distribution
unit (PDU) of the rack.
For details, see
units of an expansion
3.
Connect expansion racks 1 and 2.
For details, see
9.5.3 Installing the SPARC M10-4S in the expansion
racks
In the expansion racks installed in 9.5.2, mount the SPARC M10-4S that was changed
to 1BB configurations in 9.5.1. Then, perform installation work.
1.
Mount the SPARC M10-4S in the rack.
For details, see
2.
Set the ID required for identifying each chassis (BB-ID).
For details, see
3.
Connect the crossbar cables and XSCF BB control cables to each chassis.
Crossbar cables (optical) and XSCF BB control cables are already laid in the
expansion rack. The work here is to connect the cables to each port of the
mounted chassis. Connect the cables according to the instructions written on the
labels.
For details on the connection of the cables that pass between the racks, see
For a cable connection diagram and a cable list, see
16BB Configuration (Connections through Crossbar
4.
Connect serial cables, LAN cables, and power cords to crossbar boxes.
For details, see
5.
Connect the system management terminal to the crossbar box of the master
XSCF, and then perform an initial diagnosis of the system.
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
274
"3.2.5 Confirming the delivered components of an expansion
"3.3.1 Connecting the power cords to the power distribution
rack."
"3.3.3 Connecting
"3.4.2 Mounting the SPARC M10-4/SPARC M10-4S in a
"4.1 Setting the ID (BB-ID) Identifying a
Connecting crossbar cables" and
"5.4 Connecting Cables to a Crossbar
"3.4.2 Mounting the SPARC
rack."
racks."
"4.3.3 Connecting XSCF
rack."
Chassis."
cables."
"B.5 9BB Configuration to
Boxes)."
Box."
"4.3.2