Fujitsu M10 Installation Manual page 221

- XSCF-LAN#0 of XBBOX#81 (standby XSCF)
- XSCF-LAN#1 of XBBOX#81 (standby XSCF)
Figure 7-3 Example of XSCF-LAN settings
XBB0X#80
Master XSCF
LAN#0
192.168.1.x (1)
Remarks - For XSCF LAN ports with the same number, set addresses on the same subnet.
- Configure XSCF-LAN#0 of XBBOX#80 and XSCF-LAN#0 of XBBOX#81 on the same subnet.
(See (1) in Figure 7-3.)
- Configure XSCF-LAN#1 of XBBOX#80 and XSCF-LAN#1 of XBBOX#81 on the same subnet.
(See (2) in Figure 7-3.)
Remarks - Set different network addresses for the IP addresses of XSCF-LAN#0 and
XSCF-LAN#1.
- Configure XSCF-LAN#0 of XBBOX#80 and XSCF-LAN#1 of XBBOX#80 on different
subnets. (See (1) and (2) in
- Configure XSCF-LAN#0 of XBBOX#81 and XSCF-LAN#1 of XBBOX#81 on different
subnets. (See (1) and (2) in
Remarks - Set one takeover IP address for each pair of XSCF-LAN#0 and XSCF-LAN#1. (See
(3) in Figure 7-3.)
For details on the settings, see
1.
Execute the setnetwork command with network interface information specified.
The following example sets IP addresses and net masks for XSCF-LAN#0 and
XSCF-LAN#1 of XBBOX#80 and XBBOX#81 to enable them.
XSCF> setnetwork xbbox#80-lan#0 -m 255.255.255.0 192.168.1.x
XSCF> setnetwork xbbox#81-lan#0 -m 255.255.255.0 192.168.1.y
XSCF> setnetwork xbbox#80-lan#1 -m 255.255.255.0 192.168.2.a
XSCF> setnetwork xbbox#81-lan#1 -m 255.255.255.0 192.168.2.b
LAN#1
192.168.1.y (1)
192.168.2.a (2)
192.168.2.c (3)
192.168.1.z (3)
Figure 7-3.)
Figure 7-3.)
"7.5.3 Setting a takeover IP
Chapter 7 Making the Initial System Settings
XBB0X#81
XSCF (Standby)
LAN#0 LAN#1
192.168.2.b (2)
address."
207