Fujitsu M10 Installation Manual page 128

b. Tighten the four M6 screws at four locations on the front of the chassis (A in
c. Insert the left and right hooks on the inside of the bottom of the front cover
Note - A label with the serial number of the chassis is affixed to the front cover. Be sure to
attach the front cover to the corresponding chassis.
Figure 3-53 Securing the chassis
(M6 screws)
11. Attach the cable support.
For the Type-1 cable support
●
a. From the inside of the cable support fixing bracket, align the two screws in the
b. Slide the cable support bracket toward the chassis while holding the latch (B in
c. Attach the left cable support bracket in the same manner.
d. Secure the cable support with two M3 screws (C in
e. Close the rear door of the rack, and confirm that the cable support does not
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
114
Figure 3-53) to secure it to the rack.
into the grooves at the bottom front of the chassis to attach the front cover.
FRONT
A
right cable support bracket with the circular holes at the front of the groove,
and attach the screws (A in
Figure 3-54) attached to it.
At this time, the left and right sides should have been slid the same amount
(depth) toward the chassis.
A
(M6 screws)
FRONT
Figure 3-54).
Figure 3-55).