Connecting The System Management Terminal To The Chassis - Fujitsu M10 Installation Manual

Chapter 6
Performing an Initial System Diagnosis
This chapter describes the procedures for connecting the system management
terminal, turning on the input power, and checking components.
For details on the XSCF commands executed in the respective procedures, see the
Fujitsu M10/SPARC M10 Systems XSCF Reference Manual.

Connecting the System Management Terminal to the Chassis

■
Turning on the input power and starting the XSCF
■
Logging In to the XSCF
■
Checking the XCP Version
■
Checking the Altitude Setting
■
Checking the Time Setting
■
Performing a Diagnosis Test
■
Checking the Component Status
■
6.1 Connecting the System Management
Terminal to the Chassis
This section describes the procedures for checking the terminal software settings of
the system management terminal and connecting the system management terminal
to the serial port of the XSCF unit.
1.
Table 6-1 Terminal software setting value
Setting item
Baud rate
Data length
Parity
Confirm that the terminal software for connecting the system management
terminal has the following setting values.
Value
9600
8 bits
None
177