Fujitsu M10 Installation Manual page 304

XSCF> initbb -b bb_id
The following example releases BB#01 from the system and initializes it.
XSCF> initbb -b 1
You are about to initialize BB/XB-Box.
NOTE the following.
1. BB/XB-Box is excluded from the system and halted.
2. PPAR-ID of the same value as BB-ID becomes invalid.
Continue? [y|n] : y
Note - After the execution of the initbb command, the target chassis is released from the
system and enters the stopped state. Do not disconnect the power cords or various cables
until the XSCF STANDBY LED on the panel and the rear READY LED of the target chassis
are off.
9.
Remove the power cords from the power supply units of the target SPARC
M10-4S.
10. Remove the XSCF BB control cables from the target SPARC M10-4S.
11. Remove the crossbar cables from the target SPARC M10-4S.
12. You are performing removal to the 1BB configuration. So, remove the XSCF
DUAL control cable.
13. Remove the target SPARC M10-4S from the rack.
Remove the SPARC M10-4S from the rack by reversing the mounting procedure.
For the procedure for mounting in the rack, see
M10-4/SPARC M10-4S in a
10.2.3 Removing the server after stopping all the physical
partitions (PPARs)
This section describes the SPARC M10-4S removal procedure after stopping all the
physical partitions (PPARs). To change all SPARC M10-4Ss to a 1BB configuration as
shown in pattern B (2) in
removal.
For details on the XSCF commands executed in each step, see the Fujitsu M10/SPARC
M10 Systems XSCF Reference Manual.
1.
Log in to the master XSCF.
Execute the showbbstatus command to confirm that the XSCF to which you have
logged in is the master XSCF.
If it is a standby XSCF, retry to log in to the master XSCF.
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
290
rack."
Figure 8-3, stop all the physical partitions and then perform
"3.4.2 Mounting the SPARC