Fujitsu M10 Installation Manual page 369

Appendix C
Setup Command Workflow
This appendix describes the workflow of the XSCF commands executed in
installation of the SPARC M10 systems.
For details, see the linked sections listed in
Table C-1 XSCF setup command examples
XSCF command example
Making the initial system settings
version -c xcp
flashupdate -c sync
showaltitude
setaltitude -s altitude=100
rebootxscf -y -a
showtimezone -c tz
settimezone -c settz -a
settimezone -c settz -s
Asia/Tokyo
showdate
setdate -s 102016592012.00
testsb -v -p -s -a -y
showhardconf -M
Description
Displays the XCP version
Updates the XCP version to match it
on any chassis that has a different
XCP version
Displays the system altitude
Sets the altitude
Example: The system altitude is set to
100 m.
Resets the XSCF
Displays the XSCF time zone
Lists the time zones that can be set
Sets the time zone
Example: "Asia/Tokyo" is set.
Displays the XSCF clock date and time Yes
Sets the XSCF clock date and time
Example: 16:59:00 on 2012/10/20 in
local time (JST) is set.
Performs an initial diagnosis of the
PSB
Displays information on each FRU
Table C-1.
Mandatory? Linked section
Yes "6.4 Checking the XCP
Yes "6.4 Checking the XCP
Yes "6.5 Checking the Altitude
Setting"
Optional "6.5 Checking the Altitude
Setting"
Optional "6.5 Checking the Altitude
(*1) Setting"
No "6.6 Checking the Time
No "6.6 Checking the Time
Yes "6.6 Checking the Time
"6.6 Checking the Time
Yes "6.6 Checking the Time
Yes "6.7 Performing a Diagnosis
Test"
Yes "6.8 Checking the Component
Status"
Version"
Version"
Setting"
Setting"
Setting"
Setting"
Setting"
355