Preparing The Necessary Tools And Delivered Components For Installation - Fujitsu M10 Installation Manual

Chapter 9
Installing a System with a Building
Block Configuration
This chapter describes the procedure for installing the SPARC M10-4S in a building
block (BB) configuration.
For the installation procedure, see the relevant section corresponding to an
installation pattern shown in
Block

Preparing the Necessary Tools and Delivered Components for Installation

■
Installing the SPARC M10-4S
■
Adding Expansion Rack 1 (Installation for Expansion to Up to the 8BB
■
Configuration)
Installing Expansion Rack 2
■
Adding Expansion Racks 1 and 2
■
9.1 Preparing the Necessary Tools and
Delivered Components for Installation
This section describes the preparation for installing the SPARC M10-4S.
9.1.1 Preparing the necessary tools
The tools used to install the SPARC M10-4S are the same as those for initial
installation. See
Before starting installation work, be sure to see
installation."
Configuration."
"3.1 Preparing the Necessary Tools/Information for
"8.2 Confirming the Installation Pattern of a Building
"8.2.2 Points of concern during
Installation."
239