Fujitsu M10 Installation Manual page 226

settings made.
XSCF> applynetwork
The following network settings will be applied:
bb#00 hostname :scf0-hostname
bb#01 hostname :scf1-hostname
DNS domain name :example.com
interface :bb#00-lan#0
status :up
IP address :192.168.1.x
netmask :255.255.255.0
route :-n 0.0.0.0 -m 0.0.0.0 -g 192.168.1.1
interface :bb#00-lan#1
status :down
IP address :192.168.2.a
netmask :255.255.255.0
route :-n 0.0.0.0 -m 0.0.0.0 -g 192.168.2.1
Omitted
Continue? [y|n] : y
Please reset the all XSCFs by rebootxscf to apply the network
settings.
Please confirm that the settings have been applied by executing
showhostname, shownetwork, showroute, showsscp and
shownameserver after
rebooting the all XSCFs.
2.
Execute the rebootxscf command to reset the XSCF and complete the settings.
XSCF> rebootxscf -a
The XSCF will be reset. Continue? [y|n] : y
Execution of the command disconnects the XSCF connection.
The setting work from this step can be done through an XSCF-LAN connection
too.
To switch from a serial connection to an XSCF-LAN connection, connect to the
XSCF by specifying its IP address on a PC connected to the XSCF-LAN, and log
in again.
3.
Execute the showhostname, shownetwork, showsscp, and showroute
commands again to display the network settings, and confirm the new
network information.
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
212