Fujitsu M10 Installation Manual page 269

Maintenance/Addition Menu
Please select the chassis including added FRU.
No. FRU Status
--- ------------------- --------------
1 /BB#0 Normal
2 /BB#1 Normal
3 /BB#2 Normal
4 /BB#3 Unmount
------------------------------------------------------------------------------
Select [1,2|c:cancel] : c
5.
Diagnose the installed SPARC M10-4S.
a. Execute the testsb command to perform a diagnosis test on the installed
XSCF> testsb -v -p -s -y XX-Y
XSCF> testsb -v -p -s -y 02-0
Initial diagnosis is about to start, Continue?[y|n] :y
SB#02-0 power on sequence started.
6.
Perform a diagnosis test on the crossbar cables.
a. Execute the showboards command to check the PSB number (BB-ID)
XSCF> showboards -a
PSB PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00) (*1) Assigned n n n Passed Normal
01-0 00(01) (*1) Assigned n n n Passed Normal
02-0 SP (*2) Unavailable n n n Passed Normal
SPARC M10-4S.
Specify the PSB number of the diagnosis target PSB in XX-Y. XX is a BB-ID,
and Y is fixed at 0.
An initial diagnosis and connection I/O check are performed on the diagnosis
target PSB.
<Description of options specified>
-v: Additionally displays detailed messages of the initial diagnosis
-p: Executes the "probe-scsi-all" command of OpenBoot PROM and displays
the results while a diagnosis is being processed
-s: Executes the "show-devs" command of OpenBoot PROM and displays the
results while a diagnosis is being processed
-y: Automatically responds with "y" to a query
The following example performs a diagnosis test on the installed BB#02.
If an error is displayed, see
assigned to the physical partition stopped in step 3 and the PSB number
(BB-ID) of the installed PSB.
Chapter 9 Installing a System with a Building Block Configuration
"A.2.4 Checking diagnosis results."
255