Fujitsu M10 Installation Manual page 104

b. Remove the 10 screws securing the side plate, and remove the side plate.
Note - Be careful because work on the top cover section is done high off the ground. Never
do anything dangerous such as putting your foot on the rack, which would be very dangerous.
Note - Be careful when removing the side plate because it weighs about 13 kg.
Figure 3-18 Removing the side plate
FRONT
Number in
figure
1
2
3
4
5.
Attach M6 core spring nuts to the front and rear of expansion rack 1.
a. Attach two M6 core spring nuts in the lower part of the vertical column (right
b. Attach two M6 core spring nuts in the lower part of the vertical column (left
Fujitsu M10/SPARC M10 Systems Installation Guide ･ July 2015
90
Description
M12 screw
Top cover
Side plate
Screw
side as viewed from the front) on the connecting side at the front of the rack.
side as viewed from the rear) on the connecting side at the rear of the rack.