Fujitsu M10 Installation Manual page 103

1.
Confirm that the connecting kit supplied with expansion rack 2 is complete.
2.
Remove the front doors of expansion racks 1 and 2.
a. Open the door about 90°.
b. Lifting up the door, remove the hinge (pin) on the main body of the rack.
Then, slide the door laterally to remove it.
Caution - When attaching or removing the door, be careful not to catch your finger,
etc. in the gap between the door and rack. The notch for the front door hinge has a
bend for controlling the opening and closing angle, so you may find it difficult to
slide the door laterally.
Figure 3-17 Removing the front door
Number in Description
figure
1 Hinge on door
2 Notch for hinge
3 Bend for controlling opening and closing angle
4 Hinge on main body
3.
Remove the rear doors of expansion racks 1 and 2.
a. Open the door about 90°.
b. Lifting up the door, remove the hinge (pin) on the main body of the rack.
Then, slide the door laterally to remove it.
4.
Remove the screws securing the top cover of expansion rack 1, and remove
the side plate.
a. Use an Allen wrench to remove the two M12 screws securing the top cover, at
the front and rear on the right side, which is the connecting side. The removed
screws will not be used.
FRONT
Chapter 3 Installing the System 89