E614 Error Code - Canon imageRUNNER ADVANCE C350 series Service Manual

Error Detail
Location Item
code Code
E611 0000 07 Title Fax transmission retry error
Detection Rebooting and retransmission were repeated 3 times in a short
description period of time (12 hours).
Remedy [Related parts] Main Controller PCB (UN81) (Unit of
replacement: MAIN CONTROLLER PCB ASSEMBLY)
[Remedy] Perform the following in the order while checking
whether the error is cleared.
1. Clear fax job information by executing "COPIER>
FUNCTION> CLEAR> FXTX-CLR. Then, turn OFF and then
ON the main power.
2. Replace the Main Controller PCB.
E614 0001 00 Title Flash PCB error
Detection The Flash PCB could not be recognized, or the Flash PCB was
description not formatted.
Remedy [Related parts]
- Flash PCB (UN96)
- Main Controller PCB (UN81) (Unit of replacement: MAIN
CONTROLLER PCB ASSEMBLY)
[Points to note at work] Reinstall the necessary application
software once the error is cleared.
[Remedy] Perform the following in the order while checking
whether the error is cleared.
1. After turning OFF the main power, remove and then install
the Flash PCB to check that it is installed properly.
2. Turn ON the main power, and check whether the error is
cleared.
3. Enter safe mode using (2+8) startup, and execute [4] Clear/
Format> [2] Flash Format (Flash format) using a USB memory.
4. After replacing the Flash PCB, reinstall the system software
using SST or a USB memory.
5. Replace the Main Controller PCB.
7
Error•Jam•Alarm > Error Code > Error Code Details
Description
7 Error•Jam•Alarm > Error Code > Error Code Details
Error Detail
Location Item
code Code
E614 0002 00 Title Error in file system on the Flash PCB
Detection The file system could not be initialized normally at startup.
description When this error occurs, the system has not been started
normally. Therefore, it may not be recorded in the error log.
Remedy [Related parts]
- Flash PCB (UN96)
- Main Controller PCB (UN81) (Unit of replacement: MAIN
CONTROLLER PCB ASSEMBLY)
[Points to note at work] Reinstall the necessary application
software once the error is cleared.
[Remedy] Perform the following in the order while checking
whether the error is cleared.
1. After turning OFF the main power, remove and then install
the Flash PCB to check that it is installed properly.
2. Turn ON the main power, and check whether the error is
cleared.
3. Enter safe mode using (2+8) startup, and execute [4] Clear/
Format> [2] Flash Format (Flash format) using a USB memory.
4. After replacing the Flash PCB, reinstall the system software
using SST or a USB memory.
5. Replace the Main Controller PCB.
E614 0006 00 Title Error in file system on the Flash PCB
Detection Bootable was not found on the Flash PCB.
description
Remedy [Related parts]
- Flash PCB (UN96)
- Main Controller PCB (UN81) (Unit of replacement: MAIN
CONTROLLER PCB ASSEMBLY)
[Points to note at work] Reinstall the necessary application
software once the error is cleared.
[Remedy] Perform the following in the order while checking
whether the error is cleared.
1. After turning OFF the main power, remove and then install
the Flash PCB to check that it is installed properly.
2. Turn ON the main power, and check whether the error is
cleared.
3. Enter safe mode using (2+8) startup, and execute [4] Clear/
Format> [2] Flash Format (Flash format) using a USB memory.
4. After replacing the Flash PCB, reinstall the system software
using SST or a USB memory.
5. Replace the Main Controller PCB.
7-102
Description
7-102