Canon imageRUNNER ADVANCE C350 series Service Manual page 1035

5) Select the drive where the Font Set Software CD has been loaded, then click the
"SEARCH" button.
6) The font list in the Font Set Software CD will appear.
Click the "REGISTER" button.
9
Installation > PCL International Font Set-B1 > Installation Procedure > Register Andale Font in the USB memory device.
7) "Registered firmware" will appear. Click the "OK" button.
■ Register Andale Font in the USB memory device.
F-9-149
● SST > USB memory device
Register the system software, which has been registered in the SST, in the USB memory
device.
Preparation
Requirements:
• PC with SST Ver. 4.72 or later installed
• USB memory storage device (*)
Requirements for USB memory storage device:
Interface: USB 1.1 or later (USB 2.0 is recommended)
Memory capacity: 1GB or more is recommended (the total file size of the system software
is approx. 500MB).
Format: FAT (FAT 16), FAT32 (NTFS and HFS are not supported). The memory is formatted
in a partition (multiple partitions are not supported)
Unavailable USB memory: memory that is protected by a password or the encryption
F-9-150 technology.
System software registration procedure
1) Start the PC.
2) Insert the USB memory storage device storage device to the slot of the PC.
3) Start SST.
4) Click the USB icon shown in "Select the target" Screen.
9 Installation > PCL International Font Set-B1 > Installation Procedure > Register Andale Font in the USB memory device.
9-58
F-9-151
9-58