Canon imageRUNNER ADVANCE C350 series Service Manual page 274

2
Technical Explanation > Updater > System Management Operations > Various Setting
● Setting Log Level
This section describes how to set system log levels.
1. Start [Service Mode] at Level 1.
2. Press [Updater] button.
3. Press [Software Management Settings] button.
4. Press [Settings] button.
2 Technical Explanation > Updater > System Management Operations > Various Setting
5. Select a log level from [Log Level] dropdown list.
• [Log Level]:
Select one of 5 levels ranging from [0] to [4].
See the table below for logs output in each level.
Log Level
F-2-404
Trace
Information
Important Message
Ordinary Error
System Error
F-2-405
6. Press [OK] button to set the selected log level. Now the log level is successfully set.
Trace Information Important Message
0 - -
1 - -
2 - - Yes
3 - Yes Yes
4 Yes Yes Yes
NOTE:
This list shows the contents of the Log Output.
Log Output
Detailed logs for debug
Logs related to operations done on the system
Update logs output by firmware type
Installation logs by MEAP application
Logs related to enabled functions by system option
Logs for ordinary errors
Logs for internal system errors
2-231
F-2-406
Log Output
Ordinary Error System Error
- - Yes
- Yes Yes
Yes Yes
Yes Yes
Yes Yes
Description
2-231
T-2-97