Canon imageRUNNER ADVANCE C350 series Service Manual page 1033

Informing the System Administrator That Installation Is
Complete
When installation is complete, give the following explanation to the system administrator.
When installation is complete, inform the system administrator that the security functions
have been added, and explain the procedure for checking whether the security functions are
enabled.
This will enable the system administrator to quickly detect when the functions become
disabled and request a service call to correct the error.
Checking That Installation Is Complete:
Following the section "Checking the Security Version", display the version information of
the security chip from [Check Device Configuration] on the Control Panel, and show the
system administrator that "2.00" or "2.01" is displayed for the [Canon MFP Security Chip]
item.
Checking That the Security Functions Are Enabled:
Request the system administrator to refer to the section "Checking the Security Mark" to
confirm that the security functions are enabled each time the host machine is started by
checking the security mark.
Executing auto gradation adjustment
When this product is installed, the machine initializes its HDD, resetting the data used for
auto gradation correction.
Therefore, execute full adjustment of auto gradation adjustment after installing this kit to
enable proper images to be output.
Execution of the minimum installation work
Be sure to execute the minimum installation work in accordance with the Setup Guide
because HDD is initialized when this kit is installed.
9
Installation > HDD Data Encryption Kit-C6 > Execution of the minimum installation work
9 Installation > HDD Data Encryption Kit-C6 > Execution of the minimum installation work
9-56
9-56