Canon imageRUNNER ADVANCE C350 series Service Manual page 920

COPIER> OPTION> IMG-MCON
BGE-OFS Fine adj of background adjustment level
Lv.2 Details To make a fine adjustment of the background adjustment (background
removal) level which can be set manually.
Break up the adjustment values into smaller ones when user does
not satisfy with the default adjustment values.
Use case When color fogging occurs on the output image when copying
yellowed blank paper as an original
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Caution Since the background color is set to be washed out with this mode,
not only the background of yellowed blank paper, but also other light
colors (light blue, etc.) are washed out.
Display/adj/set range -15 to 15
Default value 0
Related UI menu Copy> Options> Density> Background Density
8
Service Mode > COPIER > OPTION > IMG-SPD
T-8-44
8 Service Mode > COPIER > OPTION > IMG-SPD
■ IMG-SPD
COPIER> OPTION> IMG-SPD
FX-D-TMP Set small ppr down sequence start temp
Lv.1 Details To set temperature to start the down sequence control to small size
paper.
As the value is incremented by 1, the temperature is increased by 2
deg C from the initial setting temperature.
Use case - When uneven gloss occurs at paper edge
- When improving productivity
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -4 to 4
-4: -8 deg C, -3: -6 deg C, -2: -4 deg C, -1: -2 deg C, 0: 0 deg C, 1: 2
deg C, 2: 4 deg C, 3: 6 deg C, 4: 8 deg C
Unit 2 deg C
Default value 0
FIX-ROT Idle rotn end temp after small ppr feed
Lv.1 Details When feeding the small size paper following the large size paper on
the Fixing Assembly, the temperature at both edges of Fixing Film is
higher than the center. To prevent the fixing offset or paper wrinkle,
it idles until the temperature becomes the specified value after the
small size paper is fed.
This item is to set the temperature to finish the idle rotation.
When the value is increased, downtime is increased because of
prioritizing image quality.
When the value is decreased, downtime is decreased, but uneven
gloss occurs.
Use case - When uneven gloss occurs at paper edge
- When improving productivity
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Display/adj/set range -2 to 2
-2: -10 deg C, -1: -5 deg C, 0: +/-0 deg C, 1: +5 deg C, 2: +10 deg C
Default value 0
8-150
8-150