Canon imageRUNNER ADVANCE C350 series Service Manual page 1037

8) Select "Start".
9) A message "Firmware export to the USB storage is completed." will appear. Select "OK".
NOTE:
The folder name "iA500" needs to be changed if the model name differs.
Press the Counter Check button to refer to the displayed model names.
Example: iR-ADV 500(iA500) -> iA500
Andale Font can be registered by a means other than the above. It can be registered by
using SST Ver.4.72 or later.
9
Installation > PCL International Font Set-B1 > Installation Procedure > Register Andale Font in the host machine
■ Register Andale Font in the host machine
● Connection
Preparation
Item to prepare: A USB memory device where the system software for this machine has been
registered
Procedure
1) If the host machine is connected with a network cable, disconnect it.
2) Connect the USB memory device to the USB port.
F-9-156
3) Switch to the download mode to use.
In the case of normal mode (Recommended)
Select the following in Service Mode: COPIER > FUNCTION > SYSTEM > DOWNLOAD;
and then press [OK].
• In the case of safe mode (This mode should not be used as general rule. To be used only
when normal startup fails, such as a system error, etc.)
• While pressing 2 + 8 keys at the same time, turn ON the Main Power Switch.
• Once this machine recognizes the USB memory storage device, the following menu is
displayed on the Control Panel.
F-9-157
9 Installation > PCL International Font Set-B1 > Installation Procedure > Register Andale Font in the host machine
9-60
F-9-158
9-60