2
Technical Explanation > Updater > Maintenance > How to Replace Devices
Maintenance
■ Upgrading Updater
The firmware installed in the device should be also upgraded when upgrading Updater. See
the section of "Version Upgrade" , Chapter 6 "Troubleshooting" for more detailed information.
■ Formatting Hard Disk
Since Updater is a MEAP application, its contents can be temporarily saved in the MEAP
application storage area on PC via SST during formatting or replacing HDD. See "MEAP" of
Chapter 2 for further information.
The settings initialized in format or replacement should be restored. See the section of
"Preparation" for more detailed information.
NOTE:
When formatting or replacing HDD, distribution schedule, downloaded firmware (not
updated yet) and logs (update/system logs) will be deleted.
■ How to Replace Controller Boards
• Main Controller Board PCB
The network and service mode setting should be set again after initialization. See the
section of "Preparation" for more detailed information.
■ How to Replace Devices
All settings should be set again because no data are inherited. See the section of
"Preparation" for more detailed information.
2
Technical Explanation > Updater > Maintenance > How to Replace Devices
2-235
2-235