6) Remove the small cover of the Controller Box Cover.(Removed small cover of the
Controller Box Cover will be used in step 1 of after Installation.)
• 1 Screw (Removed Screw will be used in step 1 of after Installation.)
1x
7) Remove the Controller Box Cover.
• 2 Connectors (Removed 2 Connectors will be used in step 1 of after Installation.)
• 1 Screw (Removed Screw will be used in step 1 of after Installation.)
• 10 Hooks
CAUTION:
When handling the hard disc, be careful not to vibrate or drop it.
2x
9
Installation > Serial Interface Kit-K2 / Copy Control Interface Kit-A1 > Installation Procedure > Installing the Serial Interface Kit-K2
F-9-25
1x
F-9-26
9
Installation > Serial Interface Kit-K2 / Copy Control Interface Kit-A1 > Installation Procedure > Installing the Serial Interface Kit-K2
■ Installing the Serial Interface Kit-K2
1) Remove the Face Plate. (Removed Face Plate will not be used.)
• 2 Screws (Removed screws will be used in step 3.)
2x
2) Connect the RS Conversion Cable and Support Plate to the Serial RS Conversion Board.
• 3 Screws (TP; M3x6)
• 1 Connector
M3x6
9-12
F-9-27
3x
1x
F-9-28
9-12