Indicator Lamp Replacement - Polaris RANGER 400 Owner's Manual

MAINTENANCE
Lights
Headlight Lamp Replacement
1. Open the hood.
CAUTION! Hot components can cause burns to skin.
Allow lamps to cool before servicing.
2. Unplug the headlamp from the wiring
harness. Be sure to pull on the connector, not
on the wiring.
3. Turn the lamp counter-clockwise to remove it.
4. Install the new lamp.
Tip: Make sure the tab on the lamp locates properly in
the housing.
5. Reinstall the harness assembly into the headlight assembly.
Brake Lights
When the brake pedal is depressed, the brake light comes on. Check the brake light before
each ride.
1. Turn the ignition switch to the ON position.
2. Depress the brake pedal. The brake light should come on after about 10mm (0.4 in.) of
pedal travel. If the light doesn't come on, check the bulb.

Indicator Lamp Replacement

1. Lift the hood.
2. Reach in behind the console panel and lift the
release to unplug the light from the harness.
3. Using a flathead screwdriver, press on the tab on
the top of the light to remove the indicator light
assembly from the console panel.
4. Locate the expired lamp. Using a screwdriver,
rotate the lamp 1/4 turn counter-clockwise.
5. Grip the lamp with a needle-nose pliers and
remove it from the assembly.
6. Install the new lamp. Using a screwdriver, rotate the lamp 1/4 turn clockwise to seat it.
7. Snap the assembly back into the console panel. Reconnect the harness.
8. Close the hood.
76
Wiring Harness
Release
Tab