Type Iv, Shaft Drive Transmission Removal; Type Iv, Shaft Drive Transmission Installation; Type Iv, Shaft Drive Transmission Disassembly; Type Iv, Shaft Drive Transmission Assembly - Polaris Trail Blazer Service Manual

Transmission Removal
All operations regarding transmission front output housing assembly can be performed with transmission installed
in frame.
1. Remove the inner PVT cover. Refer to Clutch
Chapter. Remove speedometer cable.
2. Remove complete
transmission vent line.
3. Loosen rear wheel nuts slightly.
4. Elevate and support machine under footrest/frame
area.
CAUTION: Serious injury may result if machine tips
or falls. Be sure machine is secure before beginning
this service procedure. Wear eye protection when re-
moving and installing bearings and seals.
5. Remove wheel nuts and wheels.
6. Apply hand and auxiliary brake and remove brake
disc retaining nut and washer. NOTE: Domed
side of washer faces nut.
7. Remove rear (auxiliary) brake caliper and disc
(where applicable). Support caliper on right hand
foot rest.
8. Disconnect transmission
Remove right hand shock absorber.
9. Disconnect the sway bar from both sides. Remove
right side upper control arm.
Polaris Sales Inc.
airbox assembly and
shift linkage rods.
8.15
Type lV, Shaft Drive Transmission
Domed side
toward nut
TRANSMISSION
4/99