Memo Display Function - NEC Univerge SV8100 Features And Specifications Manual

Issue 8.01

Memo Display Function

With Version 4000 or lower software, the SV8100 can display matching Caller ID but is limited to 12
characters. With Version 5000 or higher software, it can now display up to 28 Characters per line and
up to three lines of information for a total of 84 characters (Maximum 28 digits x 3 lines). If needed, the
system can be set to use any one of three available display lines. Additionally, the original CID
information can be seen while on the call by pressing the right cursor button on the phone.
Conditions
The Memo Display Function requires Version 5000 or higher software and the Version

5000 Enhancement license.
In a CCIS network the Memo Display Function is only supported for DID calls directed

across CCIS to a remote system.
Calls forwarded or transferred across CCIS do not support the Memo Display Function.

Memo information cannot be programmed via telephone programming or service access

code, only via Web Pro and PC Pro.
The Memo Display function is only supported on Multiline terminals.

The Memo Display function is only supported for incoming trunk calls with Caller ID

information.
The destination station must be idle for the Memo Display function to work.

The Memo Display function will only search the Common Speed Dial bins, it will not search

Group or Station speed dial bins.
Find the abbreviation area the side of incoming system when trunk incoming via

networking.
When calls are directed to a virtual extension, the virtual extension must be set to ring for

the Memo Display function to work.
Pressing the right Cursor key on the telephone toggles the display between the actual

incoming Caller ID information and the Memo Display settings for that incoming Caller ID
information.
When a call is on hold, pressing the Feature Key and the line key the call resides on

displays the actual incoming Caller ID information.
Default Setting
Disabled
2 - 232
UNIVERGE SV8100
Caller ID