NEC Univerge SV8100 Features And Specifications Manual page 337

UNIVERGE SV8100
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
14-01-08 Basic Trunk Data Setup – Toll
Restriction
15-02-30 Multiline Telephone Basic Data
Setup – Toll Restriction Class
20-06-01 Class of Service for Extensions
20-08-02 Class of Service Options
(Outgoing Call Service) – Trunk
Outgoing Calls
20-13-20 Class of Service Options
(Supplementary Service) –
Account Code/Toll Restriction
Operator Alert (Restricted
Operation Transfer)
Code Restriction
Description/Comments
For each trunk, enter 1 to Enable
Toll Restriction; enter 0 to Disable
Code Restriction.
Select the Toll Restriction Class to
be used when placing a call from a
virtual extension.
Assign a Class of Service (1~15)
to extensions.
Turn Off or On outgoing trunk
calling for the extension.
Turn Off or On operator alert when
an extension improperly enters an
Account Code or violates Toll
Restriction.
Assigned Data
1
0 = Restriction
Disabled (No)

1 = Restriction Enabled
(Yes)
(default = 1)
0 = Vir. Ext. (Virtual
Extension Class)

1 = Real Ext. (Real
Extension Class)
(default = 1)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:

Extension port 101 =
Class 15
All other extension port
= Class 1
0 = Off
1 = On

(default = 1 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
Issue 8.01
Level
2 3

2 - 309