NEC Univerge SV8100 Features And Specifications Manual page 862

Issue 8.01
Standard SIP terminals are not supported for Peer-to-Peer connection.

If either Programs10-26-04 or 50-15-04 are set to 0 (Disable) in system A, Peer-to-Peer is

disabled for system A and any remote systems when calling system A.
When port translation is done through a NAT router, Peer-to-Peer is disabled.

When RTP encryption is enabled, Peer-to-Peer is disabled.

When connecting to a SV8300 or SV8500 using CCISoIP, Program 84-21-21 must be set to

H.245 (2).
When connecting to other SV8100s using CCISoIP, Program 84-21-21 must be set the

same in all systems.
SV8100 K-CCIS-IP to another SV8100, for calls from an IP terminal to a TDM terminal/

trunk via Peer-to-Peer, the IP Terminal's Codec must match the CCIS Codec and the
packet size is auto negotiated based on the receiving sides packet size.
SV8100 K-CCIS-IP to another SV8100 or to a NEAX PBX (SV8300, SV8500, etc.), for calls

from an IP terminal to another IP terminal/trunk via Peer-to-Peer, the IP Terminal's Codec
must match and the packet size is auto negotiated.
SV8100 K-CCIS-IP to a NEAX PBX (SV8300, SV8500, etc.), for calls from an IP terminal to

a TDM terminal via Peer-to-Peer, the IP Terminal's Codec and packet size (Program
84-24-XX) need to match the NEAX PBX CCIS Codec and packet size settings.
With SV8100 Version 5000 (5.00 or higher) software and PZ-IPLB daughter board

installed, half duplex connections are not supported. For troubleshooting purposes, a
managed switch capable of port mirroring is required to capture packet data from the
SV8100 IPLB Ethernet port.
Default Setting
Enabled
System Availability
Terminals
None
Required Component(s)
CD-CP00-US with PZ-32/64/128IPLA or PZ-32/64/128IPLB Daughter Board
2 - 834
UNIVERGE SV8100
K-CCIS – IP