NEC Univerge SV8100 Features And Specifications Manual page 295

UNIVERGE SV8100
Automatic Route Selection
Call Appearance (CAP) Keys
Code Restriction
Dial Tone Detection
Handsfree Answerback/Forced Intercom Ringing
Long Conversation Cutoff
Microphone Cutoff
Programmable Function Keys
Trunk Group Routing
Trunk Groups
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
10-03-XX ETU Setup
11-01-01 System Numbering
Central Office Calls, Placing
Description/Comments
Use program 10-03-XX to setup
and confirm the basic
configuration data for each blade.
This program represents different
data depending on the blade
installed in the slot. Please refer
the SV8100 Programming Manual
for a more detailed description of
this program.
Set system numbering plan.
Assigned Data
1
The assigned data
varies depending on
the blade installed in
the slot. Please refer
to the SV8100
Programming Manual
for a more detailed
description of the
10-03-XX programs.
Refer to UNIVERGE
SV8100 Programming
Manual.
Issue 8.01
Level
2 3


2 - 267