NEC Univerge SV8100 Features And Specifications Manual page 234

Issue 8.01
Program
Program Name
Number
20-13-17 Class of Service Options
(Supplementary Service) –
Barge-In Tone/Display (Intrusion
Tone)
20-13-32 Class of Service Options
(Supplementary Service) – Deny
Multiple Barge-Ins
20-13-45 Class of Service Options
(Supplementary Service) – MIC
Key Mode While Call Monitoring
20-14-11 Class of Service Options for
DISA/E&M – DISA/Tie Trunk
Barge-In
20-18-07 Service Tone Timers – Intrusion
Tone Repeat Time
21-01-03 System Options for Outgoing
Calls – Trunk Interdigit Time
(External)
Operation
The call must be set up for about 10 seconds before it can be Monitored. Listen for busy/ring or busy
tone.
2 - 206
Description/Comments
Turn Off or On the Barge-In
(Intrusion) Tone. If disabled, this
also turns off the Barge-In display
at the called extension.
Allow (1)/Deny (0) the extension
user ability to have multiple users
Barge-In to their conversation.
Set per class of service, when in
Call Monitoring Mode determines
if the monitored parties receives
the barge in alert tone when
Coaching Mode is enabled.
Enable (1)/Disable (0) a DISA or
tie trunk user from using the
Barge-In feature.
After a user Barges In, the system
repeats the Barge-In tone after
this time. Normally, you should
disable this time by entering 0.
(This time also affects any other
type of call interruption features,
such as Voice Mail Conversation
Recording, Voice Over, etc.)
Program the time an extension
must wait before using the
Barge-In feature can be used on a
call (this time expires before a call
is put in a talk state). This time
also affects Voice Over.
UNIVERGE SV8100
Assigned Data
1
0 = Off
1 = On

(default = 1 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Enable
1 = Disable
(default = 1 for
COS 1~15)
0 = Off
1 = On

(default = 0 for
COS 1~15)
0~64800 (seconds)
(default = 0)
0~64800 (seconds)
(default = 5)
Call Monitoring
Level
2 3



